These are instructions on how to jailbreak your iPhone and iPad on the 5.0 and 5.0.1 firmware using RedSn0w 0.9.9b6, 0.9.9b7 and 0.9.9b8 for Windows.
This procedure will cause you to upgrade your baseband potentially ruining your chances for an unlock. The jailbreak is also tethered which means you will need to connect your device to the computer each time you reboot. Finally, it may be prudent to save your SHSH Blobs by following this tutorial before continuing.
Create a folder on your desktop called Pwnage
Download the 5.0 firmware from here and place it in the Pwnage folder. (Note: you do not need to download the 5.0 firmware if you are already on iOS 5.0)
Extract the RedSn0w zip file by double clicking it.
Step Two: (You can skip this step if iOS 5 is already installed on your device)
Connect your idevice to the computer and launch iTunes.
Select your idevice from the list of devices on the left. Now hold down Shift and click the Restore button. Restore is preferred as it won't create any wasted space on your idevice.
Navigate to the Pwnage folder on your desktop and select the 5.0 firmware ipsw. Click the Choose button to continue.
iTunes will now update your iPhone to the new firmware.
Launch the redsn0w application from the redsn0w folder we extracted earlier.
**Windows 7 users may want to try running the redsn0w executable mode as an administrator in Windows Vista compatibility. You can do this by right clicking the executable and selecting Properties from the contextual menu.
Once RedSn0w opens click the Jailbreak button
Plug your iPhone into the computer and make sure its OFF then click the Next button
RedSn0w will now guide you through the steps to get into DFU mode. You can find more help with DFU mode here
Hold down both the Home button and the Power button for 10 seconds.
Release the Power button and continue holding the Home button until RedSn0w detects the device.
Your iPhone will now reboot
RedSn0w will now prepare the jailbreak data.
Select Cydia from the list of options and click Next.
Your iPhone will now be rebooted again and RedSn0w will begin uploading the new RAM Disk and Kernel.
Once this is complete you will be notified that RedSn0w is done. When your iPhone finishes rebooting (5 minutes or so) it will be jailbroken with Cydia on the SpringBoard.
Once you have jailbroken you will need to rerun redsn0w to boot tethered.
From the main RedSn0w menu click the Extras button.
Select Just boot from the Extras menu to just boot tethered.
*As usual a big thanks to the iPhone Dev-Team and Geohot for their hard work and contribution to the iPhone community.